Displaying 1 - 10 results of 38 for ""
Published: 25 June 2006
Category:
Pavements & aggregates
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
Guidelines for the roughness requirements for finished pavement construction
Published: November 2012
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road controlling authorities
To advise of the compliance testing requirements for road safety hardware systems.
Published: November 2014
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
This technical memorandum provides advice on the recommended practice for the design and installation of transitions between wire rope safety barriers (WRSB) and semi-rigid and rigid barrier systems. The barrier configurations in the memo are generic…
Published: May 2006
Category:
Surfacings & asphalt
,
Technical memoranda
| Audiences:
Road controlling authorities,
Road traffic engineers & consultants
This report identifies possible methods and constraints on the use of waste tyre rubber in asphalt in New Zealand.
Published: 1 July 2008
Category:
Structures (bridges, culverts & geotechnical)
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
This memo provides details of revisions to Transit New Zealand specification P/24: 2008 and the NZ Transport Agency Endorsed RSMA compliance standard for traffic signs that were implemented on 1 July 2008.
Published: August 2021
Category:
Structures (bridges, culverts & geotechnical)
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
This memorandum provides information for practitioners on the calculation of road superelevation appropriate for a vehicle speed and curve radius.
Published: 11 June 2009
Category:
Skid resistance & surface texture
,
Technical memoranda
| Audiences:
Road traffic engineers & consultants,
Roading contractors
The 2008 SCRIM survey was an outlier.
Published: December 2011
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
To advise on the recommended practice for using low strength concrete around guardrail posts that are installed in hard surfaces such as concrete footpaths.
Published: 13 January 2011
Category:
Surfacings & asphalt
,
Technical memoranda
| Audiences:
Road traffic engineers & consultants,
Roading contractors
The procedure for assessing bitumens for acceptance by the penetration test shows the calculations used to set the acceptance limits shown in table 1 of M1 notes:2010.
Published: 30 April 2014
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
To advise on the recommended practice for the design and installation of a ground beam for the support of semi-rigid road safety barrier systems. This design applies to public domain systems only.
