Bridge end marker posts (figure 6-9) should be installed on bridge end posts, road safety barriers, or other such width restrictions that come within the clear or trafficable approach width of the road.

Bridge end marker post details

Dimensions for Bridge end marker posts, which can be sourced from the Signs specifications are summarised in Table 6‑14.

Signs specifications

Table 6‑14: Specification for Bridge end marker posts

Colour (left hand side)

Three white retroreflective diagonal stripes

Colour (right hand side)

Three yellow retroreflective diagonal stripes

Background

Matte black

Height

Minimum 900mm

Width of marker

150mm (minimum)

Figure 6‑9: Bridge end markers – W20-5.1 and W20-5.2

Two marker posts where the left post is a white retroreflective diagonal stripes and on the right is a yellow retroreflective diagonal stripes

Installation of Bridge end marker posts

With regards to the installation of Bridge end marker posts, refer to Figure 6‑10.

Bridge end marker posts should be positioned:

  • on, or in front of the width restriction; and
  • in the case of road safety barrier, immediately in advance of the point at which the face of the road safety barrier is closest to the centre-line of the road.

The top of the post should be a minimum of 1.0m above the road surface. The posts should be installed on one or both sides of the road as applicable and facing oncoming traffic. W20-5.1 Bridge end marker post – left side white and black must be used on the left-hand side of the road and W20-5.2 Bridge end marker post – right side yellow and black must be used on the right. The diagonal stripes on the posts should slope downward towards the road.

For situations where width constraints are associated with unprotected hazards (eg unprotected bridge abutments) higher levels of width delineation may be appropriate.

The installation of bridge end marker posts should be in accordance with the guidance in Section 7 of TCD Manual Part 1 including that they should be frangible when installed in clear zones.

Figure 6‑10: Width marker installation details

(a) Plan

Layout plan of bridge end marker posts

View larger image [JPG, 795 KB]

(b) Elevation

Layout of a bridge end market post in elevation showing the appropriate height and width

View larger image [JPG, 364 KB]