Resources

This specification applies to the marking of sealed and paved road surfaces in paint and thermoplastic road marking materials that are reflectorised by means of an application of glass beads.

This specification and guidance notes apply to the installation of raised pavement markers.

This specification describes technical, testing and certification requirements for temperature controlled raised pavement marker heaters to be used for work with NZ Transport Agency P14 Specification for raised pavement markers installation (P14) and…

The M12 Specification for the Design, Manufacture, Installation and Maintenance of Raised Pavement Markers, NZTA M12-S, and associated documents M12-F (Field Test for Raised Pavement Markers, M12-C (Certificate and Worksheet Templates for Raised Pave…

These specifications must be met where a vehicle inspector chooses to use a noise meter to assess exhaust noise as part of the WoF inspection.

This procedure defines standard nomenclature and methods of measurement for describing the location of test points on state highways.

This specification for pre-surfacing repairs replaces the specifications TNZ C4, C5, C6, C7 and C8.

This method describes the use of the standpipe permeameter to assess the permeability of compacted hot mix asphalt pavement surfacings.

This specification and guidance notes set out the performance requirements for: single coat reseals using sealing chip with an average dimension greater than 5.5mm; multilayer seals using sealing chips in the range of grade 2 to grade 6, as defined i…

This test procedure covers the determination of the rebound deflection of a pavement under a standard wheel load and tyre pressure, with or without temperature measurements.