Resources

WITHDRAWN - This specification and associated notes covered the design, fabrication and testing of tubular section, galvanised steel friction fit jointed street light columns of the ground planted, flange mounted and frangible base type.

This specification sets out the material requirements for five size grades of sealing chip for use on state highways and other heavily trafficked roadways.

The M01 bitumen specification and notes set out the requirements for bitumen used for pavements in New Zealand.

This specification sets out the requirements for the removal and disposal from the surface of the carriageway and drainage channels of detritus as requires removal.

This specification applies to the marking of sealed and paved road surfaces in paint and thermoplastic road marking materials that are reflectorised by means of an application of glass beads.

This specification and guidance notes apply to the installation of raised pavement markers.

This specification describes technical, testing and certification requirements for temperature controlled raised pavement marker heaters to be used for work with NZ Transport Agency P14 Specification for raised pavement markers installation (P14) and…

The M12 Specification for the Design, Manufacture, Installation and Maintenance of Raised Pavement Markers, NZTA M12-S, and associated documents M12-F (Field Test for Raised Pavement Markers, M12-C (Certificate and Worksheet Templates for Raised Pave…

These specifications must be met where a vehicle inspector chooses to use a noise meter to assess exhaust noise as part of the WoF inspection.

This procedure defines standard nomenclature and methods of measurement for describing the location of test points on state highways.