Displaying 31 - 37 results of 37 for ""
Published: December 2011
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
To advise on the required practice for installation and maintenance of M19 3 bolt shear base lighting columns to ensure safe operation.
Published: 22 December 2005
Category:
Skid resistance & surface texture
,
Technical memoranda
| Audiences:
Road traffic engineers & consultants,
Roading contractors
This memo advises macrotexture requirements for low speed areas and supersedes the two earlier asset management memos.
Published: 31 May 2017
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
This standard drawing shows details of the accepted grading profile for guardrail terminals accepted in NZ Transport Agency specification M23.
Published: 28 June 2006
Category:
Road delineation & signs
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
This memo provides advice on the use of the Dent breakaway system in sign installations.
Published: 28 June 2006
Category:
Approvals
,
Technical memoranda
| Audiences:
Road traffic engineers & consultants,
Roading contractors
Approval of 6mm OCLYTE short stub TM manufactured by CSP Pacific including conditions for use.
Published: 6 April 2023
Category:
General circulars
,
Technical memoranda
| Audience:
Local & regional government
General circulars are used by Waka Kotahi NZ Transport Agency to directly advise road controlling authorities and regional councils about relevant policy or programme management updates, or to communicate recent Board decisions.
Published: September 2015
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
The Transport Agency temporary concrete road safety barrier design (TCB-1) is a metricated variant of the Oregon State Department of Transport (ORDoT) F-shape “Precast Concrete Barrier Pin and Loop Assembly” (RD500).
