Displaying 1 - 10 results of 37 for ""
Part of the ‘General circulars’ resource.
Category: General circulars , Technical memoranda | Audience: General
General circulars are used by Waka Kotahi NZ Transport Agency to directly advise road controlling authorities and regional councils about relevant policy or programme management updates, or to communicate recent Board decisions.
Published: 25 June 2006
Category:
Pavements & aggregates
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
Guidelines for the roughness requirements for finished pavement construction
Published: November 2012
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road controlling authorities
To advise of the compliance testing requirements for road safety hardware systems.
Published: November 2014
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
This technical memorandum provides advice on the recommended practice for the design and installation of transitions between wire rope safety barriers (WRSB) and semi-rigid and rigid barrier systems. The barrier configurations in the memo are generic…
Published: May 2006
Category:
Surfacings & asphalt
,
Technical memoranda
| Audiences:
Road controlling authorities,
Road traffic engineers & consultants
This report identifies possible methods and constraints on the use of waste tyre rubber in asphalt in New Zealand.
Published: 1 July 2008
Category:
Structures (bridges, culverts & geotechnical)
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
This memo provides details of revisions to Transit New Zealand specification P/24: 2008 and the NZ Transport Agency Endorsed RSMA compliance standard for traffic signs that were implemented on 1 July 2008.
Published: August 2021
Category:
Structures (bridges, culverts & geotechnical)
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
This memorandum provides information for practitioners on the calculation of road superelevation appropriate for a vehicle speed and curve radius.
Published: 11 June 2009
Category:
Skid resistance & surface texture
,
Technical memoranda
| Audiences:
Road traffic engineers & consultants,
Roading contractors
The 2008 SCRIM survey was an outlier.
Published: December 2011
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
To advise on the recommended practice for using low strength concrete around guardrail posts that are installed in hard surfaces such as concrete footpaths.
Published: 13 January 2011
Category:
Surfacings & asphalt
,
Technical memoranda
| Audiences:
Road traffic engineers & consultants,
Roading contractors
The procedure for assessing bitumens for acceptance by the penetration test shows the calculations used to set the acceptance limits shown in table 1 of M1 notes:2010.
