Displaying 201 - 210 results of 516 for ""
Published: 1981
Category:
Monitoring
,
Network
,
Specifications
| Audiences:
Road traffic engineers & consultants,
Roading contractors
This procedure defines standard nomenclature and methods of measurement for describing the location of test points on state highways.
Published: March 2015
Category:
Activity management
,
CAPTIF
,
Research programme
,
Research & reports
| Audiences:
Road traffic engineers & consultants,
Roading contractors
The objectives of this study were to investigate the relationship between permeability of chipseals, waterfilm thickness, basecourse moisture sensitivity, heavy traffic volumes, and premature pavement failure following construction through the use of…
Published: 10 December 2007
Category:
Travel demand management
,
Manuals
| Audiences:
Road traffic engineers & consultants,
Roading contractors
This manual provides practical advice and assistance in interpreting and putting into practice travel demand management techniques.
Published: May 2005
Category:
Planning, design, funding, building, maintenance of the transport network
,
Guidance for specialists
| Audiences:
Road traffic engineers & consultants,
Roading contractors
Papers from the Surface Friction conference, held in Christchurch, New Zealand in May 2005.
Published: October 2014
Category:
Activity management
,
Research programme
,
Research & reports
| Audience:
Roading contractors
The research investigated aspects of the use of epoxy modified bitumen for construction of chip seals.
Published: 2006
Category:
Pre-surfacing repairs
,
Maintenance
,
Specifications
| Audiences:
Road traffic engineers & consultants,
Roading contractors
This specification for pre-surfacing repairs replaces the specifications TNZ C4, C5, C6, C7 and C8.
Published: 2003
Category:
Construction
,
Asphalt
,
Specifications
| Audiences:
Road traffic engineers & consultants,
Roading contractors
This method describes the use of the standpipe permeameter to assess the permeability of compacted hot mix asphalt pavement surfacings.
Published: May 2014
Category:
Corporate publications
| Audience:
Roading contractors
The purpose of this document is to communicate our state highway annual work programme.
Published: 2 March 2020
Category:
Project & contract management
,
Manuals
| Audiences:
Road traffic engineers & consultants,
Roading contractors
A manual for use by Waka Kotahi NZ Transport Agency when preparing state highway tender documents for maintenance contracts.
Published: October 2012
Category:
Construction
,
Chipsealing
,
Specifications
| Audiences:
Road traffic engineers & consultants,
Roading contractors
This specification and guidance notes set out the performance requirements for: single coat reseals using sealing chip with an average dimension greater than 5.5mm; multilayer seals using sealing chips in the range of grade 2 to grade 6, as defined i…
